FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
similar accommodation where such use does not exceed (average) domestic usage levels. • Do not change the specification of this appliance. • The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 10 (1) bar (MPa) • Follow the maximum number of 14 place settings. •...
Page 6
• Warning: this appliance is designed to be installed / connected to a grounding connection in the building. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Always use a correctly installed shockproof socket.
Refer to Safety chapters. 3.1 Building in min. 560 www.youtube.com/electrolux www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher 1240 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
Page 8
appliance and may cause an injury. If the plastic cover is damaged, contact the Authorized Service Centre to replace it with the new one. 5 mm ENGLISH...
Scan the QR code with the camera on your mobile device to be redirected to My AEG The lamp goes off when you close the door or Kitchen app in the app store. Follow the switch the appliance off.
5. CONTROL PANEL On/Off button / Reset button Option buttons (EXTRAS) Delay start button / Remote start button AUTO Sense program button Display MY TIME program selection bar 5.1 Display 5.2 ECOMETER The ECOMETER indicates how the programme selection impacts energy and water consumption.
45 °C. programme for test institutes. 6.4 Extras in the app 6.2 AUTO Sense My AEG Kitchen app provides additional The AUTO Sense programme automatically dishwashing options. To access all options, adjusts the dishwashing cycle to the type of connect your dishwasher to the app.
Page 12
Cleaning 70 °C Refer to "Care and Cleaning". • Intermediate rinse • Final rinse • AirDry Automatic door opening during the drying phase. Refer to "Basic settings". Available only through My AEG Kitchen app. Available only through My AEG Kitchen app. ENGLISH...
Consumption values Water (l) Energy (kWh) Duration (min) Programme 1)2) Quick 11.0 0.620 Pre-rinse 0.010 11.8 0.970 1h 30min 11.9 1.110 2h 40min 11.9 1.210 0.644 AUTO Sense 12.1 1.220 Machine Care 10.6 0.710 The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
Page 14
You can change the basic settings in setting The lights related to the Previous, OK and mode. Next are on. When the appliance is in setting mode, the How to change a setting bars of the ECOMETER represent available settings. For each setting, a dedicated bar of Make sure the appliance is in setting mode.
Page 16
Each performed softener rinse (possible more than one in the same cycle) may prolong the programme duration by another 5 minutes when it occurs at any point at the beginning or in the middle of a programme. All the consumption values mentioned in this section are determined in line with the currently applicable standard in laboratory conditions with water hardness...
8. WIRELESS CONNECTION You can connect your dishwasher to the 1. Launch My AEG Kitchen app on your home wireless network and then link it to your mobile device and follow the instructions mobile devices in My AEG Kitchen app.
If you want to cancel the procedure, switch Refer to "Daily use" to activate the remote the appliance off and on. start. 8.2 How to deactivate the wireless 8.4 How to reset the network connection credentials If you want to connect to a different wireless Press and hold simultaneously network or update the credentials of the for 2 seconds.
4. Carefully shake the funnel by its handle to CAUTION! get the last granules inside. 5. Remove the salt around the opening of The compartment (B) is for rinse aid only. the salt container. Do not fill it with detergent. CAUTION! Only use rinse aid designed specifically for dishwashers.
Page 20
10.1 Using the detergent How to activate the remote start Make sure that the indicator is on and your dishwasher is added in My AEG Kitchen app. If not, refer to "Wireless connection". 1. Press • The light related to the button is on.
Page 21
• The ECOMETER indicates the When you set the delay start, the remote start updated level of energy and water is automatically activated. consumption. During the countdown, you cannot change the programme selection. You can change the delay time in the app. By default, options must be activated When the countdown is complete, the every time before you start a programme.
After closing the door, the countdown The function comes into operation resumes. automatically: • When the programme is completed. • After 5 minutes if a programme was not started. Opening the door while the appliance operates may affect the energy 10.11 End of the programme consumption and the programme duration.
Page 23
no additional agents), rinse aid and salt • The cap of the salt container is tight. separately for optimal cleaning and drying • The spray arms are not clogged. results. • There is enough salt and rinse aid (unless • Detergent tablets do not fully dissolve with you use multi-tablets).
12. CARE AND CLEANING 12.2 Internal cleaning WARNING! • Clean the appliance interior with a soft Before any maintenance other than damp cloth. running the programme Machine Care, • Do not use abrasive products, abrasive deactivate the appliance and disconnect cleaning pads, sharp tools, strong the mains plug from the main socket.
Page 25
5. Make sure that there are no residues of food or soil in or around the edge of the 1. Turn the filter (B) counterclockwise and sump. remove it. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides.
Page 26
CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 12.6 Cleaning the lower spray arm We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes. Clogged holes can cause unsatisfactory washing results.
Page 27
4. To install the spray arm back, press the spray arm upwards and simultaneously turn it counterclockwise until it locks into place. 2. Move the upper basket to the lowest level to reach the spray arm more easily. 3. To detach the spray arm (C) from the 12.8 Cleaning the ceiling spray arm delivery tube (A), turn the mounting element (B) counterclockwise and pull the...
13. TROUBLESHOOTING Refer to the below table for information on WARNING! possible problems. Improper repair of the appliance may With some problems, the display shows an pose a danger to the safety of the user. alarm code. Any repairs must be performed by qualified personnel.
Page 29
Problem and alarm code Possible cause and solution Technical malfunction of the appli‐ • Switch the appliance off and on. ance. The display shows iC0 or iC3. The level of water inside the appli‐ • Switch the appliance off and on. ance is too high.
Page 30
Problem and alarm code Possible cause and solution The display shows upd. All buttons • The appliance downloads and installs the firmware update automatical‐ are inactive except for the on/off ly when it is available. The display shows upd for the duration of the button.
Page 31
Problem Possible cause and solution Poor drying results. • Tableware was left for too long inside the closed appliance. Activate the function AirDry to set the automatic opening of the door and to improve the drying performance. • There is no rinse aid or the dosage of rinse aid is not sufficient. Fill the rinse aid dispenser or set the dosage of rinse aid to a higher lev‐...
Page 32
Problem Possible cause and solution Limescale deposits on the tableware, • The level of salt is low, check the refill indicator. on the tub and on the inside of the • The cap of the salt container is loose. door. •...
Problem Possible cause and solution The app cannot connect to the dish‐ • There is a trouble with the wireless network signal. Check your wire‐ washer. less network and router. Restart the router. • Check if your mobile device is connected to the network. •...
15. ENVIRONMENTAL CONCERNS appliances marked with the symbol with Recycle materials with the symbol . Put the the household waste. Return the product to packaging in relevant containers to recycle it. your local recycling facility or contact your Help protect the environment and human municipal office.
Page 36
My AEG Kitchen app The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)