Installing A Hot-Swap Hard Disk Drive - Lenovo ThinkServer TS200 Installation And User Manual
Lenovo thinkserver ts200: user guide
Hide thumbs
Also See for ThinkServer TS200:
- Hardware maintenance manual (298 pages) ,
- Installation and user manual (258 pages) ,
- Manual d’installation et d’utilisation (254 pages)
Table of Contents
Advertisement
Installing a hot-swap hard disk drive
This procedure applies only to server models that have hot-swap hard disk drives.
Before you install a hot-swap hard disk drive, read the following information:
v The hot-swap drives must be either all SAS hard disk drives or all SATA hard
v Inspect the drive tray for signs of damage.
v To maintain proper system cooling, do not operate the server for more than 10
v You do not have to turn off the server to install hot-swap drives in the hot-swap
v See "Removing and installing internal drives" on page 43 for additional
To install a hot-swap hard disk drive (based on your model), complete the following
steps.
Table 13. IDs of the hot-swap drives (models with four drive bays)
Drive bay
4
5
6
7
disk drives; the two types cannot be combined.
minutes without either a drive or a filler panel installed in each drive bay.
drive bays.
information.
ID
0
1
2
3
Chapter 5. Installing and replacing optional devices
51
Advertisement
Table of Contents
