Installing An Adapter - Lenovo ThinkServer TS200 Installation And User Manual
Lenovo thinkserver ts200: user guide
Hide thumbs
Also See for ThinkServer TS200:
- Hardware maintenance manual (298 pages) ,
- Installation and user manual (258 pages) ,
- Manual d’installation et d’utilisation (254 pages)
Table of Contents
Advertisement
Installing an adapter
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter. Adapter that
the server supports might vary, depending on your server model.
v Locate the documentation that comes with the adapter and follow those
v Read the documentation that comes with your operating system.
v The server comes with the following adapter connectors or slots:
v Some server models come with a ServeRAID-BR10il SAS/SATA RAID controller
v You can install full-length adapters that are included in the supported options list
v The 32-bit slots 4 and 5 support 5.0 V keyed PCI adapters; they do not support
v The server scans PCI Express Gen 2 x8 (x8) slot 1, PCI Express Gen 2 x8 (x8)
v See http://www.lenovo.com/thinkserver and click the Options tab for a list of
To install an adapter, complete the following steps.
Note: Static electricity that is released to internal server components when the
server is powered-on might cause the server to stop, which might result in the loss
of data. To avoid this potential problem, always use an electrostatic-discharge wrist
strap or other grounding system when you work inside the server with the power
on.
instructions in addition to the instructions in this section. If you must change the
switch setting or jumper settings on the adapter, follow the instructions that come
with the adapter.
– Slot 1, PCIe2 x8 (x8, x4, x1) 25W
– Slot 2, PCIe2 x8 (x8, x4, x1) 25W
– Slot 3, PCIe2 x1 10W
– Slot 4, PCI 32bit, 33MHz
– Slot 5, PCI 32bit, 33MHz
installed. The ServeRAID-BR10il controller enables integrated RAID levels-0 and
level-1.
in slots 1 through 5 (depending on your model).
3.3 V keyed adapters. Universal adapters are supported in slots 4 and 5 if they
are universally keyed.
slot 2, PCI Express Gen 2 x4 (x4) slot 3, and PCI slots 4 and 5 to assign system
resources. Then, the server starts the PCI devices in the following order, if you
have not changed the default startup sequence: PCI Express Gen 2 x8 (x8) slot
1, PCI Express Gen 2 x8 (x8) slot 2, PCI Express Gen 2 x4 (x4) slot 3, PCI slot
4, and PCI slot 5.
supported options.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 29.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the side cover. See "Removing the side cover"
on page 32.
3. Follow the cabling instructions, if any, that come with the adapter. Route the
adapter cables before you install the adapter.
4. Follow the instructions that come with the adapter to set jumpers or switches, if
any.
5. Rotate the rear adapter-retention bracket to the open position and remove it
from the server.
Chapter 5. Installing and replacing optional devices
57
Advertisement
Table of Contents
