Installing A Hard Drive - Dell PowerEdge T605 Systems Hardware Owner's Manual
Hide thumbs
Also See for PowerEdge T605 Systems:
- Getting started with (129 pages) ,
- Getting started manual (59 pages) ,
- Manual (26 pages)
Table of Contents
Advertisement
Installing a Hard Drive
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Unpack the replacement hard drive and prepare it for installation.
2 Check the documentation for the hard drive to verify that the drive is
configured for your system.
3 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
4 Open the system. See "Opening the System" on page 68.
5 If you are replacing a hard drive, remove the drive that you are replacing.
See "Removing a Hard Drive" on page 82.
If there is a hard-drive bracket in the empty hard-drive bay, remove the
bracket by pressing the two carrier release tabs toward each other and
pulling it up and out of the drive bay. See Figure 3-9.
If a replacement hard drive does not have the hard-drive bracket attached,
remove the bracket from the old drive.
6 Snap the new drive into the guide bracket. See Figure 3-10.
7 Insert the guide bracket assembly into the drive bay until it snaps into
place. See Figure 3-9.
84
Installing System Components
Many repairs may only be done by a certified service technician. You
Advertisement
Table of Contents
Troubleshooting
