Table of Contents
Advertisement
Read the safety information in "Safety" on page v and "Installation guidelines" on page 35.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To install a 3.5-inch simple-swap hard disk drive, complete the following steps.
Step 1.
Unlock the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When you lock the left-side
cover, it locks both the cover and the bezel.
Step 2.
Open the bezel (see "Opening the bezel media door" on page 38).
Step 3.
Remove the filler panel, if one is present.
Step 4.
Touch the static-protective package that contains the disk drive to any unpainted metal surface on
the server; then, remove the disk drive from the package and place it on a static-protective surface.
Step 5.
Grasp the black drive handle and slide the blue release latch to the right and align the drive
assembly with the guide rails in the bay.
3.5-inch
simple-swap
hard disk drive
Figure 38. Simple-swap hard disk drive installation
Step 6.
Gently push the drive into the bay until the drive stops.
If you have other devices to install or remove, do so now.
Installing a DVD drive
Use this information to install a DVD drive.
If you are replacing a drive, make sure that:
• You have all the cables and other equipment that are specified in the documentation that comes with the
new drive.
• You have checked the instructions that come with the new drive to determine whether you must set
any switches or jumpers in the drive.
Filler panel
Drive handle
Release latch
.
Chapter 2
Installing optional devices
57
Advertisement
Table of Contents
Troubleshooting
