Preparation Of Ice Cubes; Energy Saving Advice; Defrosting; Fridge Section - AEG SANTO Series Operating Instructions Manual

Electronic refrigerator/freezer

Hide thumbs Also See for SANTO Series:

Table of Contents

Preparation of Ice Cubes

1. Fill ice cube tray 3/4 full with cold water and place in the freezer tray

or a drawer and allow to freeze.

2. To remove the finished ice cubes twist the ice cube tray or hold under

running water for a short time.

Warning! Do not, under any circumstances, free an ice tray which is

frozen to the appliance with pointed or sharp edged objects. Use a

spoon-handle or similar object.

• Do not install the appliance close to sources of heat, such as a cooker,

dishwasher or radiator.

• Locate the appliance in a cool well ventilated room and make sure

that the air openings of the appliance are not obstructed.

• Always leave warm food to cool down to room temperature before

placing in the freezer.

• Try to avoid keeping the door open for long periods or opening the

door too frequently as warm air will enter the cabinet and cause the

compressor to switch on unnecessarily often.

• Ensure there are no obstructions preventing the door from closing

properly.

• Place frozen goods into the refrigerator for thawing. Cold from fro-

zen goods is thus used for cooling in the refrigerator.

• Always keep the condenser at the back of the appliance clean.

Fridge section defrost automatically.

The defrosted water is fed into the drip tray on the compressor and

evaporated there.

818 37 09-01/6

Table of Contents