Show Interface Capabilities - Cisco Nexus 5000 Series Command Reference Manual
Interface
Hide thumbs
Also See for Nexus 5000 Series:
- Cli configuration manual (660 pages) ,
- Configuration manual (334 pages) ,
- Operation manual (45 pages)
Table of Contents
Advertisement
Show Commands
show interface capabilities
To display detailed information about the capabilities of an interface, use the show interface capabilities
command.
show interface ethernet slot / port capabilities
Syntax Description
ethernet slot /port
Command Default
None
Command Modes
EXEC mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
You can use the show interface capabilities command only for physical interfaces.
If the interface and transceiver speed is mismatched, the SFP validation failed message is displayed when you
enter the show interface ethernet slot/port command. For example, if you insert a 1-Gigabit SFP transceiver
into a port without configuring the speed 1000 command, you will get this error. By default, all ports are 10
Gigabits.
Examples
This example shows how to display the interface capabilities for a specific interface:
switch# show interface ethernet 1/1 capabilities
Ethernet1/1
Model:
Type (SFP capable):
Speed:
Duplex:
Trunk encap. type:
Channel:
Broadcast suppression: percentage(0-100)
Flowcontrol:
Rate mode:
QOS scheduling:
CoS rewrite:
ToS rewrite:
SPAN:
UDLD:
Link Debounce:
Specifies an Ethernet interface slot number and port
number. The slot number is from 1 to 255, and the
port number is from 1 to 128.
Modification
This command was introduced.
N5K-C5020P-BF-XL-SU
SFP-H10GB-CU1M
1000,10000
full
802.1Q
yes
rx-(off/on),tx-(off/on)
none
rx-(6q1t),tx-(1p6q0t)
no
no
yes
yes
yes
Cisco Nexus 5000 Series Interfaces Command Reference
show interface capabilities
111
- Quick Links:
- Interface Ethernet
Hide quick links:
Advertisement
Chapters
Table of Contents
