Load-Interval - Cisco Nexus 5000 Series Command Reference Manual
Interface
Hide thumbs
Also See for Nexus 5000 Series:
- Cli configuration manual (660 pages) ,
- Configuration manual (334 pages) ,
- Operation manual (45 pages)
Table of Contents
Advertisement
L Commands
load-interval
To change the sampling interval for statistics collections on interfaces, use the load-interval command. To
return to the default sampling interval, use the no form of this command.
load-interval [counter {1| 2| 3}] seconds
no load-interval [counter {1| 2| 3}] [ seconds ]
Syntax Description
1 | 2 | 3
seconds
Command Default
1—30 seconds; 60 seconds for VLAN network interface
2—300 seconds
3—not configured
Command Modes
Interface configuration mode
network-adminvdc-admin
Command History
Release
5.1(3)N1(1)
Usage Guidelines
Use the load-interval command to obtain bit-rate and packet-rate statistics for three different durations.
You can set the statistics collection intervals on the following types of interfaces:
• Ethernet interfaces
• Port-channel interfaces
• VLAN network interfaces
You cannot use this command on the management interface or subinterfaces.
This command sets the sampling interval for such statistics as packet rate and bit rate on the specified interface.
Specifies the number of counters configured on the
interface.
Specifies the interval between sampling statistics on
the interface. The range is from 60 to 300 seconds for
VLAN network interfaces, and the range is from 30
to 300 seconds for Ethernet and port-channel
interfaces.
Modification
This command was introduced.
Cisco Nexus 5000 Series Interfaces Command Reference
load-interval
69
- Quick Links:
- Interface Ethernet
Hide quick links:
Advertisement
Chapters
Table of Contents
