Lacp System-Priority - Cisco Nexus 5000 Series Command Reference Manual
Interface
Hide thumbs
Also See for Nexus 5000 Series:
- Cli configuration manual (660 pages) ,
- Configuration manual (334 pages) ,
- Operation manual (45 pages)
Table of Contents
Advertisement
lacp system-priority
lacp system-priority
To set the system priority of the switch for the Link Aggregation Control Protocol (LACP), use the lacp
system-priority command. To return the system priority to the default value, use the no form of this command.
lacp system-priority priority
no lacp system-priority
Syntax Description
priority
Command Default
System priority value is 32768.
Command Modes
Global configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
Each device that runs LACP has an LACP system priority value. You can configure a value between 1 and
65535. LACP uses the system priority with the MAC address to form the system ID and also during negotiation
with other systems.
When setting the priority, note that a higher number means a lower priority.
Examples
This example shows how to set the LACP system priority for the device to 2500:
switch(config)# lacp system-priority 2500
Related Commands
Command
show lacp
Cisco Nexus 5000 Series Interfaces Command Reference
66
Priority for the physical interfaces. The range of valid
numbers is from 1 to 65535 .
Modification
This command was introduced.
Description
Displays LACP information.
L Commands
- Quick Links:
- Interface Ethernet
Hide quick links:
Advertisement
Chapters
Table of Contents
