Download Print this page

Replacing A Hard Disk Drive; Installing The New Heat Sink - Lenovo THINKCENTRE 9120 Replacement Manual

Lenovo computer hardware installation and replacement guide

Hide thumbs Also See for THINKCENTRE 9120:

Table of Contents

7. Position the new heat sink on the microprocessor socket and then position the

Figure 21. Installing the new heat sink

8. Reconnect the heat sink and the fan assembly cable to the system board.

9. Go to Chapter 4, "Completing the parts replacement," on page 43.

Replacing a hard disk drive

This section provides instructions on how to a replace the hard disk drive.

Hardware Installation and Replacement Guide

clamp on the plastic retention bracket. Pivot the handle 1 to clamp the heat

sink to the plastic retention bracket.

Attention

Do not open your computer or attempt any repair before reading the "Important safety

information" in the Safety and Warranty Guide that was included with your computer. To

obtain a copy of the Safety and Warranty Guide, go to the Support Web site at

http://www.lenovo.com/support.

Important

When you receive a new hard disk drive, you also receive a set of Product

Recovery discs. The set of Product Recovery discs will enable you to restore the

contents of the hard disk to the same state as when your computer was

originally shipped from the factory. For more information on recovering

factory-installed software, refer to "Recovering software" in your User Guide.

1. Remove the computer cover. See "Removing the cover" on page 11.

2. Disconnect the signal and power cables from the hard disk drive.

Table of Contents