Locating The Spare Retainer Bracket - Lenovo THINKCENTRE 9120 Replacement Manual

Lenovo computer hardware installation and replacement guide

Hide thumbs Also See for THINKCENTRE 9120:

Table of Contents

Figure 12. Locating the spare retainer bracket

Hardware Installation and Replacement Guide

2. Remove the front bezel by releasing the three plastic tabs on the left side and

pivoting the bezel outward. Carefully set the bezel to the side without

disconnecting the power switch and LED assembly cable.

Note: Notice the spare retainer bracket 1 attached to the side of the upper

drive cage.

3. Remove the metal static shield from the drive bay using your fingers to pull it

outward.

4. If you are installing a drive with accessible media, such as an optical drive,

remove the plastic panel in the bezel for bay 2 by squeezing the plastic tabs

that secure the panel on the inside of the bezel.

5. If you are installing any type of drive other than a serial ATA drive, make

sure the drive that you are installing is set correctly as either a master or a

slave device.

Note: A serial ATA drive does not need to be set as either a master or a slave

device.

If you are installing a parallel ATA drive, set it as a master device. Refer to the

documentation that comes with your drive for master/slave jumper

information.

6. Remove the retainer bracket from the upper driver cage by sliding it

downward.

Table of Contents