Table of Contents
Advertisement
Connecting Hardware Devices
Maintenance overview
Never disassemble the server more than described in this manual. Failure to
observe this precaution could result in electric shock, cause a system fault, or void
your warranty.
When performing maintenance on the server, follow these general steps:
1
Carefully read the precautions mentioned previously in this chapter. See
optional devices
2
If the server is running, shut down the operating system, turn off all the peripheral
devices connected to the server, then press and hold the power button to turn off the
server. For more information, see
3
Unplug the power cable from the AC outlet or UPS (uninterruptible power supply),
then disconnect all signal cables connected to the I/O connectors on the back of the
server.
4
Remove the server's access panel.
❖
For pedestal models, see
❖
For rack models, see
5
Perform the required maintenance.
Make sure that components handled during system maintenance are properly
installed and connections are securely seated. Also check that no tools or
hardware items are left inside the server.
6
Reinstall the server's access panel.
❖
For pedestal models, see
❖
For rack models, see
7
Reconnect all signal cables.
8
Plug the power cable into an AC outlet.
9
Press the power button to turn on the server, then run any required system checks.
Some optional devices require you to reconfigure the server's software and change
jumper, and/or DIP switch settings before the device can be used. For more information,
see
BIOS Setup Utility
on page 48.
Turning off the server
Removing the side panel (pedestal model)
Removing the top panel (rack models)
Replacing the side panel (pedestal model)
Replacing the top panel (rack models)
on page 106.
Maintenance overview
Installing
on page 46.
on page 30.
on page 31.
on page 31.
on page 32.
50
Advertisement
Table of Contents
