Table of Contents
Advertisement
INSTALLER SETTING
196
INSTALLER SETTING (For 4 Series)
• You can set the product user functions.
• Some functions may not be displayed/operated in some product types.
Segmentation
Select Temperature
Sensor
Use Heating Tank Heater
Mixing Circuit
Configuration
Use External Pump
RMC master/slave
LG Therma V Configuration
Forced operation
Pump Prerun/Overrun
General
Water Flow Control
settings
Energy Monitoring
Anti-Freezing Operation
Password Reset
Heating temp. setting
Air heating set temp.
Water heating set temp.
Hysteresis Heating Water
Room
Heating
Hysteresis Room Air (Heating) Heating air temperature Hysteresis range setting
Pump setting in heating
Heater on temperature
Screed drying
Functions
Selection for setting temperature as air
temperature or leaving water temperature or air +
leaving water temperature
Set up to control booster heater
This function is to use mixing circuit function. Set
enable/disable mixing circuit function and valve
closing time and hysteresis.
Set up to control an external water pump
Function to use 2 remote control environment
Function to save the environment settings of the
product for use in LG Therma V Configurator
through SD Card.
Water pump off After 20 consecutive hours, disable /
enable the logic that drives the water pump by itself
Set to reach the optimum flow rate by circulating the
heating water with the water pump before heat
exchange. After the operation stop, additional water
pump is activated to circulate the heating water.
Set water pump to control the water flow
Set up to use energy monitoring function of unit
This function is to turn on/off the freeze prevention
operation of the pump when the remote control is off.
It is the function to initialize (0000) the password when
you forgot the password set in the remote controller.
At the water control in heating mode, the control
reference water temperature position setting
Adjusting range of 'Setting Air Temperature' in
heating mode
Adjusting range of 'Setting Heating Flow
Temperature' in heating mode
Heating Water Outlet Temperature Hysteresis
range setting
Set water pump on/off interval option during
thermo off condition in heating mode
Setting outdoor air temperature where half capacity
of backup heater starts operation.
This function controls floor heating to a specific
temperature for a certain period of time to cure
floor cement
Description
Advertisement
Table of Contents
