Feature Lacp - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

feature lacp

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

feature lacp

To enable Link Aggregation Control Protocol (LACP), which bundles a number of physical ports

together to form a single logical channel, use the feature lacp command. To disable LACP on the switch,

use the no form of this command.

Syntax Description

This command has no arguments or keywords.

Command Default

LACP is disabled.

Command Modes

Configuration mode

Command History

4.0(0)N1(1a)

Usage Guidelines

You must remove all the LACP configuration parameters from all EtherChannels on the switch before

you can disable LACP.

Even after you enable LACP globally, you do not have to run LACP on all EtherChannels on the switch.

You enable LACP on each channel mode using the channel-group mode command.

This example shows how to enable LACP EtherChannels on the switch:

switch(config)# feature lacp

Related Commands

Cisco Nexus 5000 Series Command Reference

feature lacp

no feature lacp

Modification

This command was introduced.

Displays information on LACP.

Basic System Commands