System Default Switchport - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Fibre Channel Commands

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

system default switchport

To configure port attributes for Fibre Channel interfaces, use the system default switchport command.

To disable port attributes, use the no form of the command.

Syntax Description

Command Default

Command Modes

Configuration mode

Command History

4.0(0)N1(1a)

Usage Guidelines

Attributes configured using this command are applied globally to all future switch port configurations,

even if you do not individually specify them at that time.

This command changes the configuration of the following ports to administrative mode F:

This command does not affect non-F ports that are up; however, if non-F ports are down, this command

changes the administrative mode of those ports.

The following example shows how to configure port shutdown:

switch(config)# system default switchport shutdown

The following example shows how to configure the trunk mode:

switch(config)# system default switchport trunkmode auto

system default switchport {shutdown | trunk mode {auto | off | on}}

no system default switchport {shutdown | trunk mode {auto | off | on}}

Disables or enables switch ports by default.

Configures the trunking parameters as a default.

Configures the trunking mode.

Enables autosense trunking.

Disables trunking.

Enables trunking.

Modification

This command was introduced.

All ports that are down.

All F ports that are up, whose operational mode is F, and whose administrative mode is not F.

system default switchport

Cisco Nexus 5000 Series Command Reference