Image Setup For Dos - Lenovo T560 Manual
Hide thumbs
Also See for T560:
- Hardware maintenance manual (112 pages) ,
- User manual (186 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Image Setup for DOS
i
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm
up. If this happens, switch off
the monitor and switch it on
again after a few seconds.
i
If you are using PC-DOS/V,
change to U.S. mode by
typing 'CHEV US' and pressing
ENTER at the command
prompt.
You must use when you run
DOS Auto Setup.
i
The size and diversity of
the dot pattern varies with
the screen resolution.
i
If the screen flickers,
repeat the setup several
times until the flicker is
minimised, or adjust it manually
by following refer to
Manual Setup on page 10.
1. Turn on the monitor first; then the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
• that the video interface cable is not connected properly.
• the correct video adapter card is not installed.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Insert the diskette labelled 'IBM Monitor Installation Disk' into the
diskette drive.
4. Display the command prompt screen of the DOS full-screen display.
5. At the command prompt, type 'A:' and press ENTER.
6. Type 'TESTPATD' and press ENTER.
7. Select from the screen the number for the color or text mode you want
to setup.
8. Select from the screen the number for the video mode you want to
setup.
You may repeat this process for as many of the color and video modes
as you need.
9. When the dot pattern appears, press the OSD Enter button
bottom of the monitor to display the initial OSD menu.
10. Use an Arrow button (
and press the OSD Enter button
11. Using an Arrow button (
Enter button
. This activates the AUTO SETUP procedure, which will
optimize the display settings with the provided dot patterns.
The image may be affected during this procedure and you may notice
small changes to the test pattern.
12. When finished, the OSD main menu returns.
Press the Exit button
13. Press the ESCAPE key to exit the test pattern program.
14. Type 'Exit' at the command prompt to return to Windows.
If you use other operating systems, perform the appropriate Image Setup
for those systems, also: see
Image Setup Windows 3.1, Windows 95, Windows 98, Windows 2000,
Windows Me or Windows NT® 4.0 workstation on page 7.
or
), to select the IMAGE SET-UP icon
to access the function.
or
), select AUTO and press the OSD
to exit from the OSD.
at the
9
- Quick Links:
- Hardware Requirements
Hide quick links:
Advertisement
Table of Contents
