Auto Setup For Windows3.1, 95 Or Windows2000, Windows Me Or Windows Nt - Lenovo T560 Manual
Hide thumbs
Also See for T560:
- Hardware maintenance manual (112 pages) ,
- User manual (186 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Auto Setup for Windows 3.1, 95 or Windows 2000, Windows®Me or
Windows NT
i
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
i
The size and diversity of the
dot pattern varies with the
screen resolution.
i
Position the mouse pointer
at the bottom center of the
screen. This allows AUTO
SETUP to run properly
1. Turn on the monitor first; then the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
• that the video interface cable is not connected properly.
• the correct video adapter card is not installed.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Ensure that the icon bar and tool bar, if displayed are at the bottom of
the screen.
4. Insert the diskette labelled 'IBM Monitor Installation Disk' into the
diskette drive.
5. Check the operating system installed on your computer and follow the
instructions from the table below.
Operating
System
Windows 3.1
Windows 95
Windows 98
Windows 2000
Windows Me
Microsoft Windows NT®4.0
6. When the test pattern appears, press the OSD Enter button
bottom of the monitor to display the initial OSD menu.
7. Use an Arrow button (
and press the OSD Enter button
8. Using an Arrow button (
Enter button
. This activates the AUTO SETUP procedure, which will
optimize the display settings with the provided test pattern. The image
may be affected during this procedure and you may notice small
changes to the test pattern.
To abort the AUTO SETUP function, press the ESC key.
9. When finished, the OSD main menu returns. Press the Exit button
once to exit from the OSD.
Step1
Step2
Open
Select
PROGRAM
RUN
Manager
Select
Select RUN
START
or
), to select the IMAGE SET-UP icon
to access the function.
or
), select AUTO and press the OSD
Step3
Type
'A:\TESTPAT'
and press
ENTER
at the
7
- Quick Links:
- Hardware Requirements
Hide quick links:
Advertisement
Table of Contents
