Vesa Wall Mounting - Lenovo T560 Manual

Hide thumbs Also See for T560:

Table of Contents

VESA Wall Mounting

Alternative mounting options for your IBM Flat Panel Monitor may be available

from specialist suppliers.

To attach the monitor to an arm or a surface of wall, please follow the

instructions below:

1. Power off the monitor, and then disconnect the signal cable and the power

cord from the monitor.

(A)

2. Fold the monitor arm in the order of Figure (A), (B) and (C) as shown above.

3. Place the monitor on a stable and shock-resistant floor, with the front of the

monitor at the bottom.

Metal clip

4. Hold the metal clip and push it carefully until it clamps both of the stand and the

arm firmly, as shown in Figure (D) above. (The metal clip is used to keep the

arm folded.)

5. You have to use the four screw holds on the bottom of the stand to attach the

monitor to the surface of wall. For additional information, see the instructions

supplied with the purchased arm.

6. Locate a place to which you want to attach the monitor. When locating the

place, you have to consider the lengths of the signal cable and the power cord.

7. Attach the monitor to the place you selected in the step 6, and then reconnect

the signal cable and the power cord to the monitor.

To obtain the correct cables and/or to get further instructions on

installing them, call the IBM HELPCENTER at the above numbers or

contact your dealer, retailer, or other IBM authorized Servicer.

(B)

Screw holds

( )

(C)

Table of Contents

Show Quick Links

Table of Contents