Manual Image Setup - Lenovo T560 Manual
Hide thumbs
Also See for T560:
- Hardware maintenance manual (112 pages) ,
- User manual (186 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Manual Image Setup
i
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
10
Normally, you can complete the setup procedure using Image S
however, if your screen image is still distorted after you perform Image S
or the setup diskette does not run on your system, perform M
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button
the initial OSD menu.
4. Use an Arrow button (
and press the OSD Enter button
5. Using an Arrow button (
press
once to select COARSE. Left and right arrow adjustment
indicators become illuminated (see page17).
6. Use the Arrow buttons to manually adjust to correct (as much as
possible) for for jitter or noise in the image, then press
changes.
7. Use an Arrow button to select FINE and press the
8. Use the Arrow buttons again to tune the image to your liking.
9. When finished, press the Exit button
OSD.
You have completed the monitor setup.
at the botton of the monitor to display
or
) to select the IMAGE SET-UP icon
to access the function.
or
), select MANUAL, press
four times to exit from the
,
ETUP
ETUP
S
.
ANUAL
ETUP
and then
to save the
button.
- Quick Links:
- Hardware Requirements
Hide quick links:
Advertisement
Table of Contents
