Monitor Installation; Connecting Your Monitor; Switching On Your Monitor - Lenovo T560 Manual

Hide thumbs Also See for T560:

Table of Contents

Monitor Installation

1. Turn off your computer and all attached devices.

2. Connect the signal cable.

The AC adapter and the analog signal cable are already connected to your

monitor

analog

When connecting the

Connect free end of the attached signal cable to the Dsub connector on the computer

and tighten the screws.

When connecting the DVI signal cable

Connect one end of the monitor signal cable to the DVI connector on the rear panel of

the monitor. Connect the other end to the DVI port on the rear panel of the computer

and tighten the screws.

3. Connect the power cord to the power adapter and then plug the power

cord into a properly grounded outlet.

(Figure A)

1. Switch on the power source to your monitor.

2. Switch on your monitor by pushing and releasing the power switch

marked [

[To switch off your monitor, push and release the power switch again.]

3. Switch on your computer.

4. Run AUTO SETUP by following the instructions in the Auto Setup

section on page 6.

Figure A)

signal cable (

(Figure B)

Table of Contents

Show Quick Links

Table of Contents