Replacing A Memory Module; Replacing A Pci Adapter - Lenovo ThinkCentre 9120 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 9120:
- Replacement manual (62 pages) ,
- User manual (76 pages) ,
- Benutzerhandbuch (74 pages)
Table of Contents
Advertisement
12. Position the heat sink on the microprocessor socket and then position the
13. Install the heat sink and fan assembly on the system board.
14. Connect the heat sink and fan assembly cable to the system board. See
15. Go to "Completing the FRU replacement" on page 110.
Replacing a memory module
This procedure describes how to remove and replace a memory module.
1. Remove the computer cover. See "Removing the cover" on page 87.
2. Locate the memory module connectors. See "Locating parts on the system
3. Remove the memory module being replaced by opening the retaining clips as
4. Position the new memory module over the memory connector. Make sure the
5. Go to "Completing the FRU replacement" on page 110.
Replacing a PCI adapter
This procedure describes how to remove and replace a PCI adapter.
1. Remove the computer cover. See "Removing the cover" on page 87.
clamp on the plastic retention bracket. Pivot the handle to clamp the heat sink
to the plastic retention bracket.
"Locating parts on the system board" on page 89.
Note: For this procedure, it helps to lay the computer on its side.
board" on page 89.
shown.
notch 1 on the memory aligns correctly with the connector key 2 on the
system board. Push the memory module straight down into the connector until
the retaining clips close.
Chapter 8. Replacing FRUs - Tower Computers
99
Advertisement
Chapters
Table of Contents
