Replacing The Hard Disk Drive - Lenovo ThinkCentre 9120 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 9120:
- Replacement manual (62 pages) ,
- User manual (76 pages) ,
- Benutzerhandbuch (74 pages)
Table of Contents
Advertisement
Replacing the hard disk drive
This procedure describes how to remove and replace the hard disk drive.
128
Hardware Maintenance Manual
Important
When a new hard disk drive is installed, a set of Product Recovery discs might
be required. The set of Product Recovery discs enable the contents of the hard
disk to be restored to the same state as when the computer was originally
shipped from the factory. For more information on recovering
factory-installed software, refer to "Recovering Software" in the User Guide.
1. Remove the cover. See "Removing the cover" on page 113.
2. Remove the drive bay assembly. See "Accessing system board components
and drives" on page 115.
3. Use the blue handle to pivot the hard disk drive and bracket upward, slide
the hard drive to the left until it is free of the retaining clips in the bottom of
the chassis, and then completely remove it from the chassis.
4. Disconnect the signal and power cables from the rear of the hard disk drive.
5. Remove the blue bracket from the failing hard disk drive by flexing the
bracket.
6. Install the new drive into the blue bracket, flex the bracket, and align the pins
1 through 4 on the bracket with the holes in the hard disk drive. Do not
touch the circuit board 5 on the bottom of the hard disk drive.
Advertisement
Chapters
Table of Contents
