Replacing The Hard Disk Drive - Lenovo ThinkCentre 9120 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 9120:
- Replacement manual (62 pages) ,
- User manual (76 pages) ,
- Benutzerhandbuch (74 pages)
Table of Contents
Advertisement
3. Install the new adapter into the same adapter connector.
4. Ensure the adapter is fully seated into the adapter connector.
5. At the rear of the computer, pivot the adapter latch to the closed position to
6. Go to "Completing the FRU replacement" on page 110.
Replacing the hard disk drive
This procedure describes how to remove and replace the hard disk drive.
secure the adapter.
Important
When a new hard disk drive is installed, a set of Product Recovery discs might
be required. The set of Product Recovery discs enable the contents of the hard
disk to be restored to the same state as when the computer was originally
shipped from the factory. For more information on recovering
factory-installed software, refer to "Recovering Software" in the User Guide.
1. Remove the computer cover. See "Removing the cover" on page 87.
Note: For this procedure, it helps to lay the computer on its side.
2. Disconnect the signal and power cables from the hard disk drive.
3. Press the release tab 1 down, slide the hard drive cage 2 back, and pivot
the hard disk drive outward as shown.
Chapter 8. Replacing FRUs - Tower Computers
101
Advertisement
Chapters
Table of Contents
