Replacing A Memory Module - Lenovo ThinkCentre 9120 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 9120:
- Replacement manual (62 pages) ,
- User manual (76 pages) ,
- Benutzerhandbuch (74 pages)
Table of Contents
Advertisement
4. Using the blue handle 1 , lift and slide the drive bay assembly forward until
Figure 3. Removing the drive bay assembly
5. Reverse this procedure to reinstall the drive bay assembly.
Replacing a memory module
This procedure describes how to remove and replace a memory module.
1. Remove the cover. See "Removing the cover" on page 113.
2. You might have to remove the drive bay assembly to access the memory
3. Remove the memory module being replaced by opening the retaining clips as
4. Position the replacement memory module over the memory connector. Make
the locating studs in the drive bay assembly are aligned with the slots on the
sides of the chassis. Pull upward on the handle to remove the drive bay
assembly completely from the chassis. Depending on what component of the
computer you want to remove, you can either disconnect the cables from the
rear of the drives or leave them connected.
connectors. See "Accessing system board components and drives" on page 115.
shown.
sure that the notch 1 on the memory module aligns correctly with the
connector key 2 on the system board. Push the memory module straight
down into the memory connector until the retaining clips close.
Chapter 9. Replacing FRUs - Desktop computers
117
Advertisement
Chapters
Table of Contents
