Completing The Fru Replacement - Lenovo ThinkCentre 9120 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkCentre 9120:
- Replacement manual (62 pages) ,
- User manual (76 pages) ,
- Benutzerhandbuch (74 pages)
Table of Contents
Advertisement
6. Replace any PCI adapters that were removed.
7. Go to "Completing the FRU replacement."
Completing the FRU replacement
After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn
1. Ensure that all components have been reassembled correctly and that no tools
2. Replace the cover.
3. Reconnect the external cables and power cords to the computer. See "Rear
4. If you have replaced the system board, you must update (flash) the BIOS. See
5. Some FRU replacements require the configuration to be updated. See Chapter 6,
110
Hardware Maintenance Manual
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
or loose screws are left inside your computer.
connectors" on page 86.
"Flash update procedures" on page 335.
"Using the Setup Utility," on page 51.
Advertisement
Chapters
Table of Contents
