Crypto Ipsec Policy - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Dell(conf)#int ten 0/4

Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64

Dell(conf)#int ten 0/6

Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64

crypto ipsec policy

Create a crypto policy used by ipsec.

crypto ipsec policy name seq-num ipsec-manual

To delete a crypto policy entry, use the no crypto ipsec policy name seq-

num ipsec-manual command.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2(0.2)

This command creates a crypto policy entry and enters the crypto policy

configuration mode for configuring the flow parameters.

Dell(conf)#crypto ipsec policy West 10 ipsec-manual

Dell(conf-crypto-policy)#

Internet Protocol Security (IPSec)

Both sides of the link must specify the same transform set.

You can create up to 64 transform sets.

Enter the name for the crypto policy set.

Enter the sequence number assigned to the crypto policy

Introduced on the Z9000, S4810, and S4820T.

Show Quick Links

Table of Contents