Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command.
Usage
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
Information
yield results.
Example
Dell#show ip igmp interface
GigabitEthernet 0/0 is down, line protocol is down
GigabitEthernet 0/5 is down, line protocol is down
GigabitEthernet 0/6 is down, line protocol is down
GigabitEthernet 0/7 is up, line protocol is down
GigabitEthernet 7/9 is up, line protocol is up
show ip igmp ssm-map
Display is a list of groups that are currently in the IGMP group table and contain SSM mapped sources.
S4810
Syntax
show ip igmp ssm-map [group]
Parameters
group
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
730
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet protocol processing disabled
Internet protocol processing disabled
Internet protocol processing disabled
Internet protocol processing disabled
Internet address is 10.87.5.250/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP activity: 0 joins, 0 leaves
IGMP querying router is 10.87.5.250 (this system)
IGMP version is 2
(OPTIONAL) Enter the multicast group address in the form
A.B.C.D to display the list of sources to which this group is
mapped.
EXEC
EXEC Privilege
Internet Group Management Protocol (IGMP)