Ipv6 Access Control Lists (Ipv6 Acls); Show Cam-Acl-Egress - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

IPv6 Access Control Lists (IPv6 ACLs)

IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking S4810 platform.

NOTE: For IPv4 ACL commands, refer to the

Important Points to Remember

Certain platforms require manual CAM usage space allotment. For more information, refer to the

Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.

Reference to an empty ACL permits any traffic.

ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by

IPv6 ACL because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed

bit must be set).

You can use the same access list name for both IPv4 and IPv6 ACLs.

You can apply both IPv4 and IPv6 ACLs on an interface at the same time.

You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).

Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.

Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.

Show information on FP groups allocated for egress ACLs.

show cam-acl-egress

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

IPv6 Access Control Lists (IPv6 ACLs)

EXEC Privilege

Introduced on the S6000.

Access Control Lists (ACL)

Show Quick Links

Table of Contents