Show Ip Traffic - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
S4810
Syntax
show ip traffic [all | cp | rp1 | rp2]
Parameters
all
cp
rp1
rp2
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
pre-Version
6.1.1.0
Usage
The following describes the show ip traffic summary shown in the following
Information
example.
IPv4 Routing
NOTE: These options are supported only on the E-Series.
(OPTIONAL) Enter the keyword all to view statistics from all
processors. If you do not enter a keyword, you also view all
statistics from all processors.
(OPTIONAL) Enter the keyword cp to view only statistics
from the Control Processor.
(OPTIONAL) Enter the keyword rp1 to view only the
statistics from Route Processor 1.
(OPTIONAL) Enter the keyword rp2 to view only the
statistics from Route Processor 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
F10 Monitoring MIB available for the ip traffic
statistics command.
Introduced on the E-Series.
909
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
