Dell S4810 Reference Manual page 943
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
tunnel tunnel-
id
vlan
Defaults
none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.5.1.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage
The Management port is enabled by default (no shutdown). If necessary, use the
Information
ipv6 address command to assign an IPv6 address to the Management port.
Example
Dell#
Dell#show ipv6 int te 0/5
TenGigabitEthernet 0/5 is up, line protocol is up
IPv6 Basics
(OPTIONAL) View information for a tunnel interface.
(OPTIONAL) View information for IPv6 VLANs.
EXEC
EXEC Privilege
Added support for tunnel interface.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe8a:e8f7
Global Unicast address(es):
2001::1, subnet is 2001::/64
2002::1, subnet is 2002::/120
2003::1, subnet is 2003::/120
2004::1, subnet is 2004::/32
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:1
ff02::1:ff8a:e8f7
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 0 milliseconds
943
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
