Show Ip Management-Eis-Route; Show Management Application Pkt-Cntr - Dell S4810 Reference Manual
Hide thumbs
Also See for S4810:
- Reference manual (1759 pages) ,
- Installing manual (58 pages) ,
- Configuration manual (17 pages)
Table of Contents
Advertisement
To disable and remove management egress interface selection (EIS) configurations,
use the no management egress-interface-selection command.
Defaults
None.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)
show ip management-eis-route
Display the management routes used by EIS.
S4810
Syntax
show ip management-eis-route
Defaults
None.
Command
EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Example
Dell#show ip management-eis-route
Destination
-----------
10.11.0.0/16
172.16.1.0/24
show management application pkt-cntr
Display the number of packets for each application type that have taken the management route.
S4810
Syntax
show management application pkt-cntr
Defaults
None.
806
Introduced on the Z9000, S4810, and S4820T.
Introduced on the Z9000, S4810, and S4820T.
Gateway
-------
ManagementEthernet 0/0
10.11.192.4
State
Route Source
-----
------------
Connected
Connected
Active
Static
Interfaces
- Quick Links:
- Boot System
- Restore Factory-Defaults
Hide quick links:
Advertisement
Table of Contents
