Interface Loopback - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

The interface group command will create all the non-existent VLANs specified

in the range. On successful command execution, the CLI switches to the interface

group context.

The configuration commands inside the group context will be the similar to that of

the existing range command.

Note: For release 9.4(0.0), the group command is supported only for VLANs and

physical interfaces.

Dell(conf)#interface group ?

gigabitethernet

tengigabitethernet

Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet

Dell(conf-if-group-vl-1-2,te-0/0)# no shutdown

Dell(conf-if-group-vl-1-2,te-0/0)# end

interface loopback

Configure a Loopback interface.

interface loopback number

To remove a loopback interface, use the no interface loopback number

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

FortyGigabit Ethernet interface

GigabitEthernet interface IEEE 802.3z

TenGigabit Ethernet interface

VLAN keyword

Enter a number as the interface number. The range is from 0

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Show Quick Links

Table of Contents