Debug Ip Bgp Ipv6 Unicast Soft-Reconfiguration - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.4.1.0

Version 7.8.1.0

Version 7.7.1.0

Version 7.2.1.0

debug ip bgp ipv6 unicast soft-reconfiguration

Enable soft-reconfiguration debugging for IPv6 unicast routes.

debug ip bgp [ipv4-address | ipv6-address | peer-group-name]

ipv6 unicast soft-reconfiguration

To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-

address | peer-group-name] ipv6 unicast soft-reconfiguration

ipv4-address |

ipv6-address

ipv6 unicast

Reapply only inbound policies.

NOTE: If you enter soft, without an in or out option,

both inbound and outbound policies are reset.

Reapply only outbound policies.

NOTE: If you enter soft, without an in or out option,

both inbound and outbound policies are reset.

Introduced on the S4820T.

Added support for IPv4 multicast and IPv6 unicast routes.

Introduced on the S4810.

Introduced on the C-Series.

Introduced on the E-Series TeraScale.

Enter the IP address of the neighbor on which you want to

enable soft-reconfiguration debugging.

Enter the name of the peer group on which you want to

enable soft-reconfiguration debugging.

Debug soft reconfiguration for IPv6 unicast routes.

Border Gateway Protocol

Show Quick Links

Table of Contents