Table of Contents
Advertisement
Functions specific to SCALANCE
5.4 iPCF
show wlan ipcf <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The iPCF settings are displayed.
5.4.2
WLAN Interface Configuration mode
This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the interface wlan 0/X command to change to
this mode.
● If you exit the WLAN Interface Configuration mode with the exit command, you return to
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the end command, you return to
the Privileged EXEC mode.
5.4.2.1
wlan ipcf
Note
This command is only available with the following KEY-PLUG:
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
With this command, you enable the iPCF mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
124
Description
WLAN interface
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid interface.
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
