Table of Contents
Advertisement
(
[<NextHop>] {vlan <vlan-id (1-4094)> [<administrative distance>]
[unicast]| [<administrative distance>] [unicast] | [<interface-type>
<interface-id>]
[<administrative distance>] [unicast]
})
The parameters have the following meaning:
Parameter
Description
Number of bits belonging to the prefix
prefix len
(from left to right)
IPv6 address of the gateway to which the selected addresses will be
NextHop
forwarded.
Keyword for a VLAN connection
vlan
Number of the addressed VLAN
vlan-id
Value for the administrative distance
administrativ
e distance
Addressing mode unicast
unicast
Type or speed of the interface
interface-
type
Module no. and port no. of the interface
interface-id
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The entry is deleted.
Further notes
You configure a static entry in the IPv6 routing table with the ipv6 route command.
You display the IPv6 routing table with the show ipv6 route command.
8.2.4
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network protocols
8.2 IPv6 protocol
Range of values / note
1 ... 128 bits
Enter a valid IPv6 address.
-
1 ... 4094
1 ... 254
Default: 1
-
Enter a valid interface.
369
Hide quick links:
Advertisement
Table of Contents
