Show Pnio - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Configuration

Call up the command with the following parameters:

show ipv6 interface [{vlan <id> | <interface-type> <interface-id>}

The parameters have the following meaning:

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

If you do not select any parameter from the parameter list, the configuration is displayed for

all available IPv6 interfaces.

The configuration is displayed.

Further notes

You enable IPv6 on the VLAN interface or on the router port with the ipv6 enable command.

You configure an IPv6 address with the ipv6 address command.

show pnio

This command shows the current PROFINET configuration.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Thiscli> or cli#

Call the command without parameters:

Keyword for a VLAN connection

Number of the addressed VLAN

Type or speed of the interface

Module no. and port no. of the interface

shows the prefix information of the IPv6 interface

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Range of values / note

Enter a valid interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents