Table of Contents
Advertisement
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting was reset to the default value.
Further notes
You configure the setting with the spanning-tree command (properties).
You display these settings and other information with the commands that start with show
spanning tree ....
7.3.4.3
spanning-tree auto-edge
Description
With this command, you enable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is enabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the no spanning-tree
auto-edge command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.3 Spanning Tree
327
Hide quick links:
Advertisement
Table of Contents
