Table of Contents
Advertisement
Security and authentication
11.4 MAC access control list
Result
The configuration of the access control lists is displayed.
11.4.1.2
show interface access lists
Description
This command shows the access control list of one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interface access-lists [{<interface-type><interface-id>|vlan
<vlan-id(1-4094)>}]
The parameters have the following meaning:
Parameter
interface-type
interface-id
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available interfaces.
Result
The access control list of the selected IP interface is displayed.
11.4.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
546
Description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid interface.
-
1 ... 4094
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
