Table of Contents
Advertisement
Network structures
7.2 VLAN
The parameter has the following meaning:
Parameters
vlan-id
Result
The Agent VLAN ID has been changed.
Further notes
You reset the dot1q-vlan setting with the base bridge-mode command.
7.2.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
7.2.3.1
switchport acceptable-frame-type
Description
With this command, you configure which types of frames the interface accepts.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
290
Description
Number of the addressed VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
1 ... 4094
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
