Table of Contents
Advertisement
Diagnostics
12.2 Syslog client
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
● If you exit the EVENTS configuration mode with the exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the end command, you return to the
Privileged EXEC mode.
12.2.2.1
syslogserver
Description
With this command, you configure the Syslog server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
syslogserver { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6
<ip6_addr>} [<port(1-65535)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
port
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
If you do not select any parameters from the parameter list, the default value is used.
604
Description
Keyword for an IPv4 address
IPv4 unicast address of the Syslog serv‐
er
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
IPv6 address of the Syslog server
Port of the Syslog server on which the
messages are received
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
Enter a valid IPv4 address.
-
Maximum of 100 characters
If you have stored a suitable do‐
main name, you can specify a host
name.
-
Enter a valid IPv6 address.
0 ... 65535
Default: 514
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
