Commands In The Global Configuration Mode; Plug; Commands In The Plug Configuration Mode - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

Functions specific to SCALANCE

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.

In Privileged EXEC mode, enter the configure terminal command to change to this mode.

Commands relating to other topics that can be called in the Global configuration mode can be

found in the relevant sections.

You exit the Global configuration mode with the end or exit command and are then in the

Privileged EXEC mode again.

With this command, you change to the Plug Configuration mode.

You are in the Global Configuration mode.

The command prompt is as follows:

cli(config)#

Call the command without parameters:

You are now in the Plug Configuration mode.

The command prompt is as follows:

cli(config-plug)#

Further notes

You exit the Plug Configuration mode with the end or exit command.

This section describes commands that you can call up in the Plug Configuration mode.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

Show Quick Links

Table of Contents