Table of Contents
Advertisement
7.1.1.3
show wlan antennas
Description
This command shows the antenna settings for the SCALANCE W700 device, for example
cable length.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan antennas <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The antenna settings of the relevant WLAN interface are displayed.
7.1.1.4
show wlan ap (access point)
Description
The command displays the configuration parameters of the access point.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
WLAN interface
Range of values / note
Enter a valid interface.
Network structures
7.1 WLAN
187
Hide quick links:
Advertisement
Table of Contents
