Table of Contents
Advertisement
Parameter
auto-save
wlan
events
nat
radius
umac
all
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 29)".
If you call up the command without parameters, only the active operational settings of all
modules and all interfaces that do not match the preset values are displayed.
Result
The selected configuration settings of the device are displayed.
The password cannot be read as plain language, instead [PASSWORD] is displayed.
4.4.2
write startup-config
Description
With this command, you save the changes to the configuration in the configuration file.
The use of this command is required in the Trial mode. It can also be used in "auto save mode".
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
*cli# or cli#
Syntax
Call the command without parameter assignment:
write startup-config
Result
The changes are saved in the configuration file.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Shows the configuration settings of the auto
save function
Shows the configuration settings of the WLAN
Shows the configuration settings of the events
Shows the configuration settings of the Network
Address Translation
Shows the configuration settings of the Remote
Authentication Dial-In User service
Shows the configuration settings of the user con‐
figuration
Shows all configuration settings
Configuration
4.4 Configuration Save & Restore
Range of values / note
-
-
-
-
-
-
-
103
Hide quick links:
Advertisement
Table of Contents
