Table of Contents
Advertisement
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan ampdu frames-limit <frames(2-64)>
The parameter has the following meaning:
Parameter
frames
Result
The number of frames is specified.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
7.1.5.9
wlan amsdu
Description
With this command, you enable the sending of A-MSDU data packets. Several MSDUs with
the same destination address are bundled into an A-MSDU and are sent together. This reduces
the network load. The function is enabled as default.
Requirement
● The IEEE 802.11n transmission standard is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan amsdu
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Number of frames that are grouped togeth‐
er in one AMPDU data packet.
Network structures
7.1 WLAN
Range of values / note
2...64
Default: 32
217
Hide quick links:
Advertisement
Table of Contents
