Table of Contents
Advertisement
Functions specific to SCALANCE
5.10 Remote capture
5.10.1
show remote capture
Description
This command shows the settings of remote capture of one or all interfaces.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show remote capture {<interface-type> <0/a-b,0/c,...> | all}
The parameters have the following meaning:
Parameter
Description
Type or speed of the interface
interface-
type
Port no. of the interface
0/a-b,0/c,...
Shows the settings of all interfaces.
all
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The settings are displayed.
5.10.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
160
Range of values / note
Specify a valid interface.
-
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
