Table of Contents
Advertisement
Security and authentication
11.3 WLAN
11.3.1.4
show wlan inter-ap-blocking allowed addresses
Description
This command shows a list of the SCALANCE W700 devices with which the clients are allowed
to communicate.
Note
The command is only available when the following requirements are met:
● Access point mode
● The SCALANCE W700 device is equipped with one of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5907-8PA00)
– W700 Security (MLFB 6GK5907-0PA00)
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan inter-ap-blocking allowed addresses vapX 0/Y
The parameters have the following meaning:
Parameter
vapX 0/Y
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The value of the update interval for ARP is shown along with a list with the following information:
● Index, the consecutive number of the list entry.
● Type, e.g. IPv4
● The IP address of the SCALANCE W700 device.
● The MAC address of the SCALANCE W700 device.
498
Description
VAP interface
Only available in client mode
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid interface.
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
