Table of Contents
Advertisement
Network structures
7.1 WLAN
Syntax
Call up the command with the following parameters:
no force roaming ip-down <index(1-10)>
The parameter has the following meaning:
Parameters
index
Result
The entry is deleted.
Further notes
You create an entry and change to the force roaming configuration with the command .
You display this setting and other information with the show wlan force roaming ip-
down command.
7.1.5
Commands in the WLAN Interface configuration mode
This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the interface wlan 0/X command to change to
this mode.
● If you exit the WLAN Interface Configuration mode with the exit command, you return to
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the end command, you return to
the Privileged EXEC mode.
7.1.5.1
wlan allowed channels
Description
This command specifies which of the permitted channels the SCALANCE W700 device can
use. A list of the permitted channels is created.
Requirement
● The "Allowed channels only" function is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
210
Description
Number of the entry
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
1 ... 10
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
