Table of Contents
Advertisement
Security and authentication
11.5 IP access control list
Syntax
Call up the command with the following parameters:
ip access-list standard<access-list-number(1-20)>
The parameters have the following meaning:
Parameter
standard
access-list-
number
Result
The access control list has been generated.
You are in the ACL Standard configuration mode.
The command prompt is:
cli(config-std-nacl)#
Further notes
You delete the IP access control list with the no ip access-list command.
You exit the ACL Standard configuration mode with the exit command.
You display the configuration of the access control list with the show access-lists
command.
11.5.2.2
no ip access-list
Description
With this command, you delete an IP access control list.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip access-list standard<access-list-number(1-20)>
556
Description
Specifies that a standard access control
list is generated
Number of the standard access control
list
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
1 ... 20
Configuration Manual, 09/2017, C79000-G8976-C324-08
Hide quick links:
Advertisement
Table of Contents
