Table of Contents
Advertisement
6.3.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
6.3.2.1
sntp
Description
With this command, you change to the SNTP configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
sntp
Result
You are now in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Further notes
You exit the SNTP configuration modewith the end or exit command.
6.3.3
Commands in the SNTP configuration mode
This section describes commands that you can call up in the SNTP configuration mode.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
System time
6.3 SNTP client
179
Hide quick links:
Advertisement
Table of Contents
