Table of Contents
Advertisement
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ipv6 path mtu discover
Result
The PMTU Discovery function is disabled.
Further notes
You enable the PMTU Discovery function with the command ipv6 path mtu discover.
You display the settings with the show ipv6 pmtu command.
8.2.3.7
ipv6 default route
Description
With this command, you configure the IPv6 default route. The IPv6 default route is an IPv6
route, that applies to all IPv6 addresses. The device only needs to know the default gateway
(NextHop) and sends all IPv6 packets to it.
The default gateway either knows all routes itself or has a default route to another default
gateway.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 default route <prefix len>
(
[<NextHop>] {vlan <vlan-id (1-4094)> [<administrative distance>]
[unicast]| [<administrative distance>] [unicast] | [<interface-type>
<interface-id>]
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network protocols
8.2 IPv6 protocol
367
Hide quick links:
Advertisement
Table of Contents
